The tank has been designed to accommodate 150mm 70.6mm cube moulds upto 36  72 cube mould and fully insulated, complete with a hinged lid, heater, thermostat and re-circulated pump. Provision of two removable racks allowing free circulation of water around each mould. The pump, drain valves and electrical equipment are housed in a compartment located at one end of the tank.

 

Recording rain gauges are used to obtain a continuous record of daily or weekly rainfall. It consists of a funnel-shaped collector at the top of the gauge and a float syphon chamber and recording mechanism just below it. the rain water collected by the collector is led into the float chamber. The float is having a central stem on which a pen assembly is fixed. The pen is moving over a daily (or weekly) chart wound over a clock drum. After every one centimetre of rainfall syphoning occurs and recording of rain starts afresh.

 

Ordinary Non recoding Rain Gauges as per 1S:5225 :1969. Rain Gauge i non- corrosive fibre glass reinforced plastic container. It consists of collector assembled with brass Ring. Funnel, Locking Rings and Base. The Rain Gauge is supplied with 2 liter bottle and a measuring cylinder. Rain Gauges are available in 200 sq. cms collection area.

 

Digital tipping bucket Rain Gauge System is weather instrument for measurement & monitoring rain rate and total rainfall. It is constructed of high impact UV protected plastic to provide reliable and low cost solution.

This consists of rain gauge sensor integrated with data logger. The rain collected by a mouth of calibrated diameter gauge, is driven via a one-piece funnel to the internal receiver which discharges onto a tilt bucket.  System is supplied with rain gauge software to configure with easy operation.

 

Digital tipping bucket Rain Gauge System is weather instrument for measurement & monitoring rain rate and total rainfall. It is constructed of high impact UV protected plastic to provide reliable and low cost solution.

This consists of rain gauge sensor integrated with data logger. The rain collected by a mouth of calibrated diameter gauge, is driven via a one-piece funnel to the internal receiver which discharges onto a tilt bucket.  System is supplied with rain gauge software to configure with easy operation.